Add new radio frequency to Trimble rover

Note: These instructions are based on the Trimble SPS985 using the SDS900 software.

  1. Hold the power button on the rover for 20 seconds to turn it off.

  2. Turn the rover back on and wait until the WiFi symbol begins to flash.

  3. Connect to the rover’s WiFi using a phone or computer (the password should be abcdeabcde).

  4. Open your device’s internet browser and enter the IP address 192.168.142.1 into the URL bar. This should load the rover’s settings page.

  5. To change the radio signal, go to Radio > Radio Configuration > Add Frequency

  6. Type the new frequency into the box and press OK.

  7. Restart the rover and reconnect the tablet to it over Bluetooth and select the new frequency.

Previous
Previous

Loss of Menus / Cannot Use File Explorer to Open Drawings

Next
Next

Folder Locations